Areas of use
Completely hardened paint on cars, commercial vehicles, motor bikes, etc.
Recommendation For Us
- Basic cleaning Before the polishing and sealing process preclean/wash the vehicles thoroughly with an alkaline product (eg with Green Star, do not use sealing shampoos). In the case of coarse pollutants such as tree sap, rust bloom, tar, etc., pre-treat with cleaning clay. Heavy to medium heavy weathering: Depending on the condition, treat the paintwork mechanically with Heavy Cut (312001) polishing compound polish and / or Feinschleifpaste (181001) (see Heavy Cut and Feinschleifpaste product information). Remove residues completely with Profi microfibre cloth. Apply Hochglanz-Antihologramm-Politur (182001) mechanically using an eccentric random orbit sander (eg Makita BO6040) and an orange antihologram pad (999256) (see product information Hochglanz-Antihologramm-Politur). Remove residues completely with Profi microfibre cloth. From here wear suitable gloves. Wipe all surfaces gently with a clean Profi microfibre cloth soaked in Silicon- & Wachsentferner and directly before the surface dries wipe again with a second, new Profi microfibre cloth* in your other hand. Only in this way can surfactants, drying aids, the oil contained in polishes, etc., be removed completely. Repolish the last streaks gently with another clean Profi microfibre cloth The paint should now have a surface free of scratches and holograms in sunlight or in a paintwork check with a sodium vapour lamp. After this step, do not touch the paintwork again with the palms or fingers (danger of interlinking faults, wear gloves) The surface is now fully prepared for 1K-Nano sealing. For working with 1K-Nano observe the recommended ambient temperature of 15-30°C. . Shake the aluminium bottle thoroughly shortly before use and fill the supplied plastic bottle (75ml). This amount is usually sufficient for a medium-sized vehicle . If not enough 1K-Nano is applied the sealing quality will suffer Apply sealant only to fully set (see information below) painted surfaces Apply 1K-Nano ideally mechanically by means of an orbital sander without forced orbit at low speed and with a black finishing pad (999292), alternatively manually with a white pad (999038) without pressure in sections (max. 1 component: bonnet, door, wing, etc.). Buff for approx. 2-3 minutes, always applying fresh sealant After these 2-3 minutes do not apply any more fresh sealant and continue to polish until a continuous film without drop formation (runs) is created. Wait for a further 2-3 minutes and then polish the now completely dry film by hand with a clean Profi microfibre cloth to a high gloss After approx. 1-2 hours reaction time the sealant has hardened, so that there is now a long-term seal that is resistant to chemicals and wear Any streaks that occur (excess product) are caused through the reaction process and can be removed after the hardening period with a Profi microfibre cloth* or are eliminated the first time the vehicle is washed (at the earliest after 3 days)
Notice
- Please check whether the product is suitable for your application Do not use this product on newly restored colors; Repainted surfaces require a 6-8 week curing period; Make sure there is enough ventilation and fresh air while working; Due to reactive components, 1K-Nano is stored in a tightly closed aluminum bottle; Pour the rest of the product back into the aluminum bottle after work, immediately close the bottle again and always keep it in a vertical position; After opening the lid of the product, the shelf life is approximately 1 year; When working with 1K-Nano, use only ultrasonic laser cut microfiber cloth, as lower quality cloths contain substances such as fabric softeners, silicone derivatives, etc., thus preventing the dye from bonding; Always use several clean cloths to avoid residue transfer and resulting unsightly surface.
